Chapter 30. Options
Options are settings that change shell and/or script behavior.
The set command enables options within a script. At the point in the script where you want the options to take effect, use set -o option-name or, in short form, set -option-abbrev. These two forms are equivalent.
#!/bin/bash
set -o verbose
# Echoes all commands before executing.
|
#!/bin/bash
set -v
# Exact same effect as above.
|
 | To disable an option within a script, use set +o option-name or set +option-abbrev. |
#!/bin/bash
set -o verbose
# Command echoing on.
command
...
command
set +o verbose
# Command echoing off.
command
# Not echoed.
set -v
# Command echoing on.
command
...
command
set +v
# Command echoing off.
command
exit 0
|
An alternate method of enabling options in a script is to specify them immediately following the #! script header.
#!/bin/bash -x
#
# Body of script follows.
|
It is also possible to enable script options from the command line. Some options that will not work with set are available this way. Among these are -i, force script to run interactive.
bash -v script-name
bash -o verbose script-name
The following is a listing of some useful options. They may be specified in either abbreviated form (preceded by a single dash) or by complete name (preceded by a double dash or by -o).
Table 30-1. Bash options
| Abbreviation | Name | Effect |
|---|---|---|
| -C | noclobber | Prevent overwriting of files by redirection (may be overridden by >|) |
| -D | (none) | List double-quoted strings prefixed by $, but do not execute commands in script |
| -a | allexport | Export all defined variables |
| -b | notify | Notify when jobs running in background terminate (not of much use in a script) |
| -c ... | (none) | Read commands from ... |
| -e | errexit | Abort script at first error, when a command exits with non-zero status (except in until or while loops, if-tests, list constructs) |
| -f | noglob | Filename expansion (globbing) disabled |
| -i | interactive | Script runs in interactive mode |
| -n | noexec | Read commands in script, but do not execute them (syntax check) |
| -o Option-Name | (none) | Invoke the Option-Name option |
| -o posix | POSIX | Change the behavior of Bash, or invoked script, to conform to POSIX standard. |
| -p | privileged | Script runs as "suid" (caution!) |
| -r | restricted | Script runs in restricted mode (see Chapter 21). |
| -s | stdin | Read commands from stdin |
| -t | (none) | Exit after first command |
| -u | nounset | Attempt to use undefined variable outputs error message, and forces an exit |
| -v | verbose | Print each command to stdout before executing it |
| -x | xtrace | Similar to -v, but expands commands |
| - | (none) | End of options flag. All other arguments are positional parameters. |
| -- | (none) | Unset positional parameters. If arguments given (-- arg1 arg2), positional parameters set to arguments. |